Locate the convenient "anchor points" on
your appliance fitting (see arrows on diagram above)
Hold screen over furnace fitting. Hook round end of spring
to back of screen over open side of anchor point
Holding circle end of installation pin, push pin through
screen and center of spring.
Place notch on center bar of lower spring coil and push
hook toward anchor point
Push spring hook past anchor point, turn, and release
slowly to hook spring in back
Keep installation pin for future use.
Note: Screen position can be adjusted using other anchor
Due to the deep corrugation of some RV siding, gaps between
the screen binding and the siding may require local caulking.