 Made in the U.S.A
Guaranteed against defects in material and workmanship
|
 |
|
 The
M800 fits the Atwood 2004 (arrow indicates anchor point)l:
-
Locate the convenient "anchor points" on
your furnace (see arrows on diagram above)
-
Hook round end of spring to back of screen over open
side of anchor point
-
Holding circle end of installation pin, push pin through
screen and center of spring.
-
Place notch on center bar of lower spring coil and push
hook toward anchor point
-
Push spring hook past anchor point, turn, and release
slowly to hook spring in back
- Note: Screen position can be adjusted using other anchor
points
Keep installation pin for future use
|
 |
|
|
