 Made in the U.S.A
Guaranteed against defects in material and workmanship
|
 |
|
 |
The W100 fits these models (arrows indicates anchor points):
 |
| For Atwood models, attach spring to door, not pre-existing
screen |
-
Locate the convenient "anchor points" on
your appliance fitting (see arrows on diagram above).
For Atwood models, attach spring to door, not pre-existing
screen
-
Hold screen over furnace fitting. Hook round end of spring
to back of screen over open side of anchor point
-
Holding circle end of installation pin, push pin through
screen and center of spring.
-
Place notch on center bar of lower spring coil and push
hook toward anchor point
-
Push spring hook past anchor point, turn, and release
slowly to hook spring in back
Keep installation pin for future use
Note: Screen position can be adjusted using other anchor
points
|
 |
|
|
